Set your miter saw to bevel left at 33 9 degrees.
Cutting inside corner crown molding with miter saw.
Slide the molding to the right side of the blade to cut the left hand piece for an outside corner.
Your saw might say 33 8 the 1 degree is not enough of a difference to matter.
One of the advantages of using a compound miter saw is that you can tilt it to make a bevel angel while rotating the saw will enable you to make a miter cut.
These two things are constant.
Using a power miter saw is the best way to cut crown moulding angles.
Again set the bevel angle at 33 9 degrees.
These include the bevel angle and the miter angle.
This will ensure a sharp cut and a seamless corner.
Turn on the saw and make the cut.
The advantage to cutting crown molding using this method is that no bevel cut is required.
For cutting the left and right inside corners place the molding upright and rotate the saw to set miter angle at 31 6 degrees.
Therefore when adjusting the saw for out of square corners the user needs to only adjust the miter system as opposed to both miter and bevel systems when laying crown materials flat.
After that make your cut in the same manner you did before.
Then make cut just like you did before.
The joints crown molding is referred as compound since the cut on every side usually has two angles.
Cuts for inside corners will always be made using 45 degree angles on your miter saw.
The saw can be set to 45 degrees to the left or 45 degrees to the right.
It s a best practice to cut crown moulding upside down on the miter saw.
The saw can be adjusted to cut at any angle set it to 45 degrees for one side of a standard 90 degree corner.
Using these techniques the inside corner is virtually seamless.
Tilt the saw to the left and set the bevel angle at 33 9 degrees if you haven t already set it.
Rotate the saw clockwise and set the miter angle at 31 6 degrees.
This method of cutting crown molding can be done with any miter saw.
You will always want to use a blade with at least 96 teeth or more.
